Hey all, pls welcome me to your club, I am from Melbourne Australia. Just bought an ST185 Group A, and am currently fixing a few problems so I can get it registered!
I had the front cv boots replaced, and re-fitted the shafts the same way I took them out, however it sounds like I am getting a strange grinding sound when the car is moving and I turn...is it possible for the shafts to be put in wrongly so that they dont fit into the gearbox thingy's properly? They bolted up fine with no problems, but just wondering if that inner gear thing at the end could not be in properly? Otherwise I am thinking it may be the tie rods too tight when I put them back in... :shrug:
Apart from that, I have replaced lots of little things like belts, steering rack boots etc with no problems, but I am waiting on a knock sensor now cos mine has died :x
I had the front cv boots replaced, and re-fitted the shafts the same way I took them out, however it sounds like I am getting a strange grinding sound when the car is moving and I turn...is it possible for the shafts to be put in wrongly so that they dont fit into the gearbox thingy's properly? They bolted up fine with no problems, but just wondering if that inner gear thing at the end could not be in properly? Otherwise I am thinking it may be the tie rods too tight when I put them back in... :shrug:
Apart from that, I have replaced lots of little things like belts, steering rack boots etc with no problems, but I am waiting on a knock sensor now cos mine has died :x