Page 1 of 1

Feeler on 91 GT or part out

PostPosted: Thu Jan 04, 2018 4:21 pm
by nate84
I have a 91 coupe GT 5spd with 315k on the trans and body and roughly 200k on the newer 5s I have in it. It has been lowered on H&R springs and has a Suspension Techniques rear Sway bar, Lower control arm brace and a cusco front strut brace. body wise it has a CS front bumper and hood with a set of JDM fenders with the markers wired to the running lights. I also have the JDM corner lamps and the 92/93 tail lights with the JDM vented corner lamp. The motor has a hotshot header and from the midpipe back needs to be replaced due to rust. It also has TRD plug wires and TRD air filter and TRD Japan short shifter. I have a 4th kid on the way and Id hate to scrap the car but it has to go. Just wanna see what you guys think. I can text someone a picture of the car. I cant figure out how to post pics.

Re: Feeler on 91 GT or part out

PostPosted: Fri Jan 05, 2018 5:23 am
by pintoBC_3sgte
What would you want for the front strut brace and trd short shifter

Re: Feeler on 91 GT or part out

PostPosted: Fri Jan 05, 2018 2:41 pm
by Mr Alltrac
If your still in Richmond, I may stop by to take a look at some of these parts.

Re: Feeler on 91 GT or part out

PostPosted: Tue Jan 09, 2018 1:17 am
by All-TracDreams
I'd love to see that CS hood, is it the factory metal one or a carbon-fiber replica?

Re: Feeler on 91 GT or part out

PostPosted: Tue Jan 09, 2018 4:40 am
by FC Zach
All-TracDreams wrote:I'd love to see that CS hood, is it the factory metal one or a carbon-fiber replica?


+1 on this. .

Re: Feeler on 91 GT or part out

PostPosted: Tue Jan 09, 2018 3:28 pm
by nate84
Its a factory hood.I ordered all the parts thru my work before bits started to be discontinued.Also I've painted it. Trust me the car is different. I dunno if anyone would want it unless they knew to paint and prep.


http://s252.photobucket.com/user/ST184R ... A.png.html

http://i252.photobucket.com/albums/hh2/ ... ELICA1.png