Hazard's not working - 93 GT

W

WarTowels

Active member
After my paint job, my hazard lights seemingly don't work.

Not sure if it's related to the dismantling I did or not.

All blinkers work. If I put one blinker on, then hit the hazard light- it shuts off.

Not sure if this is relevant info, but before, if you had a blinker on and you hit the hazards it would just turn the other blinker on.

Is there a hazard relay that maybe took a crap on me?

:shrug:

-Towels
 
U

UtahSleeper

Active member
Isn't the blinker and hazard part of the same relay/flasher?

When you disconnected the lights your removed for painting, was there any corrosion?
 
W

WarTowels

Active member
Not that I'm aware of.

But the bulbs were out, and the wires were dangling for about a month...

But the rest of the stuff works!

(Horn works too, so it's not that fuse.)

-Towels
 
G

GMan

New member
You got the EWD ? Always good to follow the circuit.
It is on Celicatech.

Let me know if you need a section though.

Usually a bad ground or something minor ? :shrug:

Regards;
 
W

WarTowels

Active member
Hmmm, well I haven't touched the switch, nor do I even know how to take it out.

Thoughts on how to test this or something?

-Towels
 
You must log in or register to reply here.
Top