Page 1 of 1

Enkei nt03

PostPosted: Sat Mar 28, 2015 4:07 am
by Mr Alltrac
How wide would you have to run the nt03 for them to be convex instead concave?
Is it even possible on an alltrac ?

Re: Enkei nt03

PostPosted: Tue Mar 31, 2015 1:42 am
by lumbercis
In a cursory search it looks like they start going concave around 9 to 9.5 inches wide with appropriate offsets. In the wheel thread someone posted 18x9.5 that looked perfect on an alltrac. You'll have to search the thread for effective offsets. I think your biggest problem is going to be finding the NT03+M with a 5x100 bolt pattern at the offsets you're looking for. But good luck. Post up if you find a fitment that works.

J