Switch to full style
The heartland
Post a reply

Re: Texas Folks

Tue May 06, 2014 7:31 pm

I might as well bump this up and check in on everyone!

Im still around but been busy restoring a 64 honda dream motorcycle. Needed something different to work on for a bit. Satan still runs but still doesnt want to run correctly until she is warm. Honestly she doesnt get driven very often at all.

~James
Members don't see the above ad. Register now

Re: Texas Folks

Wed May 07, 2014 1:26 am

I'm doing well over west in Lubbock.
90' alltrac running well. Need to replace front left wheel bearing. And find a transmission to swap in since 2nd and 3rd synchros are gone.

12' sti is running strong an sitting pretty in the garage.
13' brz is being driven by the wife, trying to save up for a full blown motorsports turbo kit :)

Re: Texas Folks

Wed May 07, 2014 1:13 pm

Nice! I used to have an extra trans laying around but got rid of it a few years back. :doh:

~James

Re: Texas Folks

Thu May 08, 2014 10:44 am

I don't have time or money to do it now anyways. Probably just gonna find a nice 205 engine/trans and refresh them, and swap them in.

Re: Texas Folks

Tue Jun 02, 2015 3:30 pm

Reviving from the dead to drop in and say hi! I'm up in the north DFW area, been trying to get my '88 track-ready for over a year now. Got blown shocks, ordered Ceika custom stuff beginning of March. Hopefully it can go around some cones before too long! Gonna need lots of bushings and a set of tires, too. How's the rest of Texas doing?

Re: Texas Folks

Sat Nov 28, 2015 4:09 pm

runt9 wrote:Reviving from the dead to drop in and say hi! I'm up in the north DFW area, been trying to get my '88 track-ready for over a year now. Got blown shocks, ordered Ceika custom stuff beginning of March. Hopefully it can go around some cones before too long! Gonna need lots of bushings and a set of tires, too. How's the rest of Texas doing?


Better late then never right? Im still alive and working on the alltrac again. Debating on if I will finish the 92 alltrac after I get done with mine. Not sure if I would get about the same amount in parts or finishing and selling.

~James
Post a reply