not12listen
New member
ok. finally had a chance to put the pump and hoses back together... i used Gorilla Glue on every washer, each thread and on the low pressure hose fitment (into the pump) too.
tomorrow i will install it, then wait a few hours before filling it and testing it.
i'd be shocked if these ever leaked again...
i've circled the portions that i applied the Gorilla Glue too. again, each surface was cleaned with a paper towel, then the Gorilla Glue was applied. the main banjo bolt (high pressure side) and the hose clamp (low pressure side) were both torque down afterwards too. so, the glue will fill in all the cracks and seal them up solid.
of course, i won't know the results until a few days/weeks have gone by. but, again, i'm doubtful that anything would leak at this point...
tomorrow i will install it, then wait a few hours before filling it and testing it.
i'd be shocked if these ever leaked again...
i've circled the portions that i applied the Gorilla Glue too. again, each surface was cleaned with a paper towel, then the Gorilla Glue was applied. the main banjo bolt (high pressure side) and the hose clamp (low pressure side) were both torque down afterwards too. so, the glue will fill in all the cracks and seal them up solid.
of course, i won't know the results until a few days/weeks have gone by. but, again, i'm doubtful that anything would leak at this point...