How to repin CDM Harness for JDM Ecu? (newbie)

Red_Celly_HKS

New member
I Have a 90 All Trac and spun a bearing about a week ago and i am doing an engine swap from a 92 GT4A i was looking at both the harnesses and noticed the connectors that go into the ecus were both different. i`ve herd of repinning the connectors but how would i go about doing that and would someone be able to supply a diagram of where to move the wires on the CDM harness or pictures? Thanks!!
 

athousandleaves

New member
Use the 92 ECU as you wont see much benifit from the GT4A engine without it.

Easiest way to do the swap is to buy an extension harness chop it and extend it by 35" so you can fit the engine harness inside the USDM side firewall hole.

Repinning a 92 harness to a 90 ECU will be a big PITA.
 
Top