Turbo Question

JDM GT Four, ST185RC and ST205.

Turbo Question

Postby MrMcQuacker » Wed Dec 04, 2013 1:29 am

Hello, So my question is I will eventually upgrade my ct26 to a to4e 57trim sooner or later and I can not seem to find a straight answer from researching. Should I or should I not Clip the exhaust wheel? also I have read that people have done 10-15degree clips. If I do go the route of clipping it, then I will go with the 10Degree clip.

Thank You for your input.
Members don't see the above ad. Register now - it's free!
MrMcQuacker
Club Member
 
Posts: 539
Joined: Sun Aug 17, 2008 11:47 pm
Location: California/NH

Re: Turbo Question

Postby Shaggz00 » Wed Dec 04, 2013 2:02 am

What is the rest of your engine setup? That's an awfully big turbo to run on a 2.0 liter. I speak from experience, you will have some major lag. Then again, if you're going for high HP, it might be just the ticket. Let's start there, and pick the proper turbo setup for you.
-Avi-
'88 ST-165(Black) - Sitting... Waiting... Quietly... in the garage under 2 inches of dust...
'88 ST-165(grey) - gone to rusty Celica heaven
'91 MKIII Supra - 98% completion!
Shaggz00
Gold Member
 
Posts: 1682
Joined: Mon Aug 09, 2004 12:13 am
Location: Silver Spring, md

Re: Turbo Question

Postby MrMcQuacker » Wed Dec 04, 2013 4:14 pm

I have a 3gen 3sgte in my st165. I have a full 3" exhaust and a aem ems4. I have it but not installed. Also got arp heat studs just sitting around have not installed those either. My power goals are about 350awhp.
MrMcQuacker
Club Member
 
Posts: 539
Joined: Sun Aug 17, 2008 11:47 pm
Location: California/NH

Re: Turbo Question

Postby MrMcQuacker » Fri Dec 06, 2013 6:02 am

300awhp for now will suffice for a while though.
MrMcQuacker
Club Member
 
Posts: 539
Joined: Sun Aug 17, 2008 11:47 pm
Location: California/NH


Return to GT Four Chat

Who is online

Users browsing this forum: No registered users and 1 guest