TheNubkins
New member
I have a few quick questions, many of which might be serious newb ones but please bare with me. I have the stock ST185 air/air intercooler and would like to do a complete PROPER swap to an ST185RC air/water intercooler setup. If it's a lot easier to just swap in certain parts I'm willing to hear that scenario as well.
1)How difficult is this to pull off?
2)Which parts from the following picture are required. If possible could you edit the picture in paint by circling all the required parts and then repost the picture? Like I said...newb questions. I would end up just getting them all but I'm not 100% sure they are all associated with the a/w intercooler setup.
3)I believe I had read something about sensors/wiring to be done/hooked up. Does my stock car have all the required plugs/ports to wire the sensor information into, and if not are these items listed on that expanded diagram?
4)Lastly will this setup work within the stock front bumper of the North American Celica AllTrac? I really would like to keep it looking stock from the exterior and do not want to switch to an RC style bumper/hood.
Any help would really be appreciated as I'd prefer this setup to a front-mount a/a for the type of driving I'll be doing, and boost I'll be running. For me it's either this setup, or the stock air/air that's currently on the car. Note: This is not the ST205 intercooler setup.
Thanks in advance for the help guys/gals,
1)How difficult is this to pull off?
2)Which parts from the following picture are required. If possible could you edit the picture in paint by circling all the required parts and then repost the picture? Like I said...newb questions. I would end up just getting them all but I'm not 100% sure they are all associated with the a/w intercooler setup.
3)I believe I had read something about sensors/wiring to be done/hooked up. Does my stock car have all the required plugs/ports to wire the sensor information into, and if not are these items listed on that expanded diagram?
4)Lastly will this setup work within the stock front bumper of the North American Celica AllTrac? I really would like to keep it looking stock from the exterior and do not want to switch to an RC style bumper/hood.
Any help would really be appreciated as I'd prefer this setup to a front-mount a/a for the type of driving I'll be doing, and boost I'll be running. For me it's either this setup, or the stock air/air that's currently on the car. Note: This is not the ST205 intercooler setup.
Thanks in advance for the help guys/gals,