SRT-4 IC

ok i was looking at the SRT4 intercooler the other day and noticed that it wasnt very tall but seemed to be rather effective in its core design... i was just wondering if this would be a possible coice for a FMIC either with the stock 185 bumper or for the 165... because its not very tall it should fit under the large support without much modification.

thoughts, comments, suggestions

yeah i was looking at that ic... i think height and width wouldnt be a problem at all... the only problem i could see would be the end tank design... worst case though you would cut those off and have new end tanks welded on...

I would definately consider that core just not for a big hp application... say in 350hp range or less