ATS Throttle Body Inlet Question

A

ALLensTRAC

New member
Hey guys just wondering what you guys used as a gasket between the Inlet and the TB? Is there a gasket for the MR2 that I can order or should I just make one? If there is a factory one available do you have the part number as our local dealer won't look anything up without a vin.
Thanks in advance,
Allen
 
L

l00k0v3rth3r3

New member
i do believe this is what you are looking for 22271‑88381 ... as a side note toyodiy.com will help you immensely when looking for part #'s
 
A

ALLensTRAC

New member
Thank you for the number. The last time I used toyodiy it sent me in the wrong direction lol. I will try it again with this and see what it gives me. Thanks again for the help, Allen
 
C

cmonteiro1

New member
I have done this two ways. 1st time I used silicone to seal the inlet to the throttle body. 2nd time, I made a gasket with gasket paper I had lying around.
 
You must log in or register to reply here.
Top