1337computing
New member
Head is rebuilt with chrome molly rings and cometic head gasket. A lot of other things were replaced when it was apart to and if not replaced was checked to make sure it was within spec. Pretty much saying it's is fresh and healthy. Right now everything is pretty much stock except for mods listed in signature. What is safe to push on stock turbo? I read that the ct26 can only handle to about 16lbs. At this point is it worth it or are you just pushing hot air and is it safe for the engine without head studs?
Mid winter I'm hoping to upgrade the turbo along with a fmic. Again is this safe for the engine without head studs? I'm not looking to go huge or push a rediculous amount but would like to get to the 250 - 300hp range. It's a fresh head and I really dont wanna pull back apart to put studs in.
Let me know what you guys think.
Mid winter I'm hoping to upgrade the turbo along with a fmic. Again is this safe for the engine without head studs? I'm not looking to go huge or push a rediculous amount but would like to get to the 250 - 300hp range. It's a fresh head and I really dont wanna pull back apart to put studs in.
Let me know what you guys think.