MrMcQuacker
New member
Hello guys, I have read somewhere that 3gen 3sgte came with a MHG. awesome!.
I just finished up a 3" exhaust and was given a AEM wideband for my bday .
My question is, I have a Slightly upgraded turbo, Its a ct26 with a bigger wheel, I was told by the shop they they put in a 58-59 trim wheel. And they bored out the intake side of my turbo quit a bit.
Here is my question. 3" exhaust, Bigger turbo, Arp Head studs, Wideband. By adding the Arp head studs in replacing the factory ones and leaving the stock gasket. By torquing the head down from 37Ft torque to now 65Ft. Will that suffice with my goal of around 17 psi daily/reliable as long as my afr's are within good range?
Also since I am going to have arp and not worry to much on blowing the head gasket. What is the most amount of PSI I can push on 3gen 540cc injectors before its a little 2 maxed.
I just finished up a 3" exhaust and was given a AEM wideband for my bday .
My question is, I have a Slightly upgraded turbo, Its a ct26 with a bigger wheel, I was told by the shop they they put in a 58-59 trim wheel. And they bored out the intake side of my turbo quit a bit.
Here is my question. 3" exhaust, Bigger turbo, Arp Head studs, Wideband. By adding the Arp head studs in replacing the factory ones and leaving the stock gasket. By torquing the head down from 37Ft torque to now 65Ft. Will that suffice with my goal of around 17 psi daily/reliable as long as my afr's are within good range?
Also since I am going to have arp and not worry to much on blowing the head gasket. What is the most amount of PSI I can push on 3gen 540cc injectors before its a little 2 maxed.