fhalperformance
New member
As promised I am here to update. Below are some pictures of what I am running right now. Its just the prototype and as such the tank is not ready. It doesnt have any provision for fuel slosh around the pickup as of yet but with only 5 gallons in it/hard cornering I have no issues to report. Havent put alot of miles on it or ran it very low on fuel as the filler neck is not finished 100 percent. The fabricator could not figure out how to fit a lock ring so I will have to redo everything but it is working as expected.
-installed on car
-it has quick disconnect plastic lines running to the filler neck. It has a 0-95 ohm sensor that I have flipped so it reads correctly just may need a 20 ohm resistor to be as close to the factory one as it can get (my factory one measured 18 ohms to 132 ohms)
-temp filler neck
-installed on car
-it has quick disconnect plastic lines running to the filler neck. It has a 0-95 ohm sensor that I have flipped so it reads correctly just may need a 20 ohm resistor to be as close to the factory one as it can get (my factory one measured 18 ohms to 132 ohms)
-temp filler neck