planning on upgrade / questions on maintnance

i am planning on putting new brakes / struts / springs in my st165. while i'm at it i have to replace a cv axle. i was wondering what else i should do while i'm at it.

bearings?
seals?

what does that normally run?
what is involved?

Are you doing most of the work yourself? for bearings if your doing the work, just remove the hub assembly and bring it to a shop to have the bearings pressed out and the new ones pressed in, shouldnt run you too much for that, otherwise I would plan on spending like 100-150 for a wheel bearing replacement, but if your already bringing it in for brakes & suspension they may be a little cheaper because all that stuff will already be pretty much taken apart.

Don't really need to replace wheel bearings unless they are bad.
Don't forget the alignment.

Chris, don't know if I said this already or not, but that's a great pic.

sorry for the highjack but, Ya a little spitshine and she gleams

Yeah she does :notworthy: