MWP":6ymafewh said:
Nice
So is your blog up to date? Its still running in limp-home mode so far?
Megasquirt can't output CAN bus packets suitable to run the EPS without specific support being added to the MS firmware.
Darn. After you told me this I found your post on the MS forums! Sadly no one has responded. That sucks though, I guess I'll just have to output from the MS to a CAN sim then to the EPS ECU.
Ya my blog was updated yesterday. It works fine in limp mode but there is like zero response at speed so I'm not feeling the road like I want.
Few questions:
What did you do about your ignition switch to get it to work with the newer one? Did you re-pin the connector?
For the firewall boot that goes around the shaft, how did you seal that off? I have a small exhaust leak and now its in my car, haha.
For the wiper switch, did you just wire it up and it started working? Mine is acting kinda wacky and I think I will have to adapt the Scion relay somehow.