MXP_57":14ys0e0z said:Hi, i'm cedric from perth, australia.
I ve got a st165 jdm with a st185 jdm engine. but was still running with the st165 ecu and loom.
I needed to swap to the st185 ecu because 1987 st165 jdm doesn't have fuel cut based on pressure from the PIM. It's measured with the air flow. So i cannot boost more than 10 psi.
I plugged everything. The car start, but the air fuel ratio is lean, and there is black coming out of the exhaust when i accelerate. I didn't test drive, just idle. Code error 32 ( open circuit on E2 or short between vc and vs.)
Could you tell me how did you do to plug FC and OX2 ?
Could it be because there s nothing plugged in PIM?
Thank you very much for your help, i 'm a bit stuck...
:wink:
Did you sort this...as i have the same ECU with no PIM etc and am in process of converting to a link g3 ecu though need to convert ot MR2 ecu wiring plugs due to connectoors... most done but any elp appreciated
Jingo