distributor wiring issue

Talk EMS and Computer related performance

distributor wiring issue

Postby bluntninja » Fri Mar 29, 2013 1:34 pm

Ok, I'm trying to finish put my 1991 all-trac back together and ran into a snag, one of several. I went to plug up my distributor and three of the four wires were disconnected.. I have the Toyota repair manuals and checked the wiring diagrams. The book says I should have L,B,Y,R (blue black yellow red ) in that order. The issue is my wires are green black yellow and red.. So I'm trying to check them at the ecu to figure out what's what. I should have a G2 G- Ne and G1. My issue is I'm not sure where the ecu is... Does anyone know what order the wires should go in?
Members don't see the above ad. Register now - it's free!
Last edited by bluntninja on Fri Mar 29, 2013 2:37 pm, edited 1 time in total.
bluntninja
Club Member
 
Posts: 33
Joined: Wed Feb 08, 2012 2:43 am

1991 Toyota Celica

Re: distributor wiring issue

Postby bluntninja » Fri Mar 29, 2013 2:16 pm

So I got some good light on the wires and my 'green' is blue. Still unsure of the order, is it from the front view of the plug of or the back? Here's a picture.
Attachments
IMAG0124.jpg
bluntninja
Club Member
 
Posts: 33
Joined: Wed Feb 08, 2012 2:43 am

1991 Toyota Celica

Re: distributor wiring issue

Postby l0ch0w » Fri Mar 29, 2013 4:14 pm

PM me... I have an easier solution...
Andrew

1991 Red Alltrac
Frankenstein engine, lots of mods :P
User avatar
l0ch0w
Established Member
 
Posts: 1137
Joined: Thu May 31, 2007 7:38 pm
Location: Lansing KS

1991 Toyota Celica


Return to EFI Corner

Who is online

Users browsing this forum: No registered users and 1 guest