Cylinder #1,4 are full of gas.. Hydra Nemisis

BayAreaAT

Active member
Recently tried to fire up the new built motor. 1200cc precision inj.

Loaded the base map. Crank the motor for about 10 sec and the cylinder gets filled with about .5 cup of gasoline.
Any one have any ideas?? Thanks in advance
 

BayAreaAT

Active member
figured out what was the issues with the fuel. Bad wiring ground

Now all my temperature reading are not working..saying -20deg cel. :x :x :x

Anyone.. please
 

ChrisD

New member
BayAreaAT®":3pkb6tx9 said:
figured out what was the issues with the fuel. Bad wiring ground

Now all my temperature reading are not working..saying -20deg cel. :x :x :x

Anyone.. please

Did you dig into your harness a bunch with the Nemesis install, or is it plug and play? First step is to check continuity between the sensor wires and ECU pins, continuity with power and ground is as it should be. Is it just water temp showing that reading? Factory sensor or aftermarket? Other 5V sensors working ok?
 

BayAreaAT

Active member
I figured it out this weekend. The sensors should’ve been Calibrated during the 2.7 update but it was not.
 
Top