Page 1 of 1

Cylinder #1,4 are full of gas.. Hydra Nemisis

PostPosted: Wed Jul 08, 2015 10:38 pm
by BayAreaAT®
Recently tried to fire up the new built motor. 1200cc precision inj.

Loaded the base map. Crank the motor for about 10 sec and the cylinder gets filled with about .5 cup of gasoline.
Any one have any ideas?? Thanks in advance

Re: Cylinder #1,4 are full of gas.. Hydra Nemisis

PostPosted: Thu Jul 09, 2015 1:08 am
by klue
injector stuck open,

Re: Cylinder #1,4 are full of gas.. Hydra Nemisis

PostPosted: Tue Jul 21, 2015 12:18 am
by BayAreaAT®
Turned out the wires +|- are both giving 12v. No ground wires. I need to see what's causing it.

Re: Cylinder #1,4 are full of gas.. Hydra Nemisis

PostPosted: Tue Jul 21, 2015 2:21 am
by RedCelicaTRD
Weird. I'm at a loss on that one.

Re: Cylinder #1,4 are full of gas.. Hydra Nemisis

PostPosted: Sat Nov 18, 2017 3:10 am
by BayAreaAT®
figured out what was the issues with the fuel. Bad wiring ground

Now all my temperature reading are not working..saying -20deg cel. :x :x :x

Anyone.. please

Re: Cylinder #1,4 are full of gas.. Hydra Nemisis

PostPosted: Mon Nov 20, 2017 8:24 pm
by ChrisD
BayAreaAT® wrote:figured out what was the issues with the fuel. Bad wiring ground

Now all my temperature reading are not working..saying -20deg cel. :x :x :x

Anyone.. please


Did you dig into your harness a bunch with the Nemesis install, or is it plug and play? First step is to check continuity between the sensor wires and ECU pins, continuity with power and ground is as it should be. Is it just water temp showing that reading? Factory sensor or aftermarket? Other 5V sensors working ok?

Re: Cylinder #1,4 are full of gas.. Hydra Nemisis

PostPosted: Mon Nov 20, 2017 9:40 pm
by BayAreaAT®
I figured it out this weekend. The sensors should’ve been Calibrated during the 2.7 update but it was not.