Ok guys, ive spoken with kris at KOracing and were going to try to get some lines made to replace the stock hard steel feed/retun lines. These will be staineless braided lines with all the correct fittings and hardware to supply high pressure oil to the turbo and retun oil to the sump.
These will be made primarly for st165 using 2nd gen turbo's when something like this makes the process of upgrading a lot easier. But can be adapted to stock st165s, or possible st185 oil coolers.
The approximate cost would be around 200 us give or take and will take a little over a month before we can get started.
Please if your intrested Post here. From experience this is one of the big problems with upgrading turbo systems on st165 and will make the process A LOT easier.
Klue
These will be made primarly for st165 using 2nd gen turbo's when something like this makes the process of upgrading a lot easier. But can be adapted to stock st165s, or possible st185 oil coolers.
The approximate cost would be around 200 us give or take and will take a little over a month before we can get started.
Please if your intrested Post here. From experience this is one of the big problems with upgrading turbo systems on st165 and will make the process A LOT easier.
Klue