spoolin_gt
New member
turbo.... :shrug:
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
turbosmart mbc...need help
- Thread starter spoolin_gt
- Start date
alltracman78
Active member
Is that where it's connected to?
I was trying to see if you had it connected to the wrong place. Turbo is good.
I was trying to see if you had it connected to the wrong place. Turbo is good.
spoolin_gt
New member
i think i know what it is...i dismantled the bc this morning...and found out the the ball bearing is pretty much stuck in the hole..i think cuz of grease and dirt....so i cleaned it up....put it back together...now..i just need to install it on the car again..and see how it goes...i'll keep you guys updated...thanks for all the input....
that might be your problem. what it sounds like is that your getting a unlimited amount of boost, and as you switch gears your your under more load so it creates more boost. its either your bal bearing or you have the hoses switched which in turn causes the actuator not to open up and regulate boost.