88alltracohio
New member
how much time do you think it would take to convert to a FMIC, by putting this, http://streetimports.com/product_details.asp?id=358, right there
FMIC
- Thread starter 88alltracohio
- Start date
Your going to find many answers along this line : Search.
Basically its not to difficult. you going to need
- to make brakets
-piping and couplers
- definately insulate, or coat the pipes
- possibly cut your rebar
- modify the gril
- probably want to clock the compressor side
since i doubt you have any mods, i would not recommend this as a first project. I strongly doubt you will see any improvement, and you will hurt your throttle response, induce pressure drop, increase spool time.
if you outline your power goal, i could recommed something else
Basically its not to difficult. you going to need
- to make brakets
-piping and couplers
- definately insulate, or coat the pipes
- possibly cut your rebar
- modify the gril
- probably want to clock the compressor side
since i doubt you have any mods, i would not recommend this as a first project. I strongly doubt you will see any improvement, and you will hurt your throttle response, induce pressure drop, increase spool time.
if you outline your power goal, i could recommed something else
FS: Air to Air IC for ST165 W/ Greddy BOV and Intake. $500.
http://alltrac.net/phpBB2/viewtopic.php?t=14206
James Unger
WWW.KORACING.NET
It pays to search AT.net
Regards;
http://alltrac.net/phpBB2/viewtopic.php?t=14206
James Unger
WWW.KORACING.NET
It pays to search AT.net
Regards;