I made a set of pedal covers for my civic and they kicked enough ass that I took them off when I sold the car, and will eventually put them on the alltrac, though I might make some a little more precisely...
They're copies of the MUGEN pedals on the top of this page (these are the real ones)
http://www.inlinefour.com/mugalracped.html
At the time, I did not have $200, and even if I did I would never spend it on pedal covers. So, for about $20, I got a sheet of 1/4" aluminum from Home Depot, and some 3M anti-slip "tape", such as what you put on outdoor stairs. (I used the tape to replicate the rough texture on the brake and clutch pedals. It lasted more than four years, before removing the pedals from the car.) I just went to town with the jig saw and a drill (to make the neat-o countersunk holes on the gas pedal!!!) The trick in the end is to bend them a bit, so they're curved and will fit the stock pedals. I used a rubber mallet and bent them over a coffee can
The ease of heel-toe down-shifting was GREATLY increased and they looked pretty righteous. The only bad part was the brake and clutch pedals were not identical as I did it all free-hand. Oh well!