TokuzoST185
New member
From that first lip? I simply ran it a couple inches too long for the entire front, so that I could make a "tab" out of the end pieces to screw into the fender well. I double side taped the portions that touched the sides, and made a large portion that folded down into the front opening of the bumper. It sat completely flush on the car, and looked pretty good. The issue came when I fiberglassed it, and then found that it didn't properly fit the RC bumper I swapped on. I'm making a new front lip right now, and hope to be finished with it some time next month. I'll post pictures of that then. With a little work, I'm sure you could take that Home Depot lip I started on and fiberglass something nice. Below is a picture of what it could look like. It just didn't fit like I wanted, so starting on a RC bumper is best.