robolt":iw3w6hng said:You could turn the hub down to 60.1
Rav4 hub center 67.1mm vs 60.1 vs 54.1
The hub shows to be 62 on the rotor...
robolt":iw3w6hng said:You could turn the hub down to 60.1
Rav4 hub center 67.1mm vs 60.1 vs 54.1
dragstang86":cwydil1a said:So what was the final verdict? Rav4 hubs work on the front? Rav4 hubs with access holes drilled for the rear? Does it change the brake offset or anything? Will the same rotors, but re-drilled for 114.3 still work front and back?
tubasteve":j4m5456c said:The rav4 front from a 97, rears on the rav4 are hub and bearing assembly. and it won't work for the rears.
CMS-GT4":2bbun7jg said:The front do not. They would be right at the edge of the circle if redrilled. The rears are larger. The center bore will also change on the fronts. The rav4 wheels bearing and axle spline is the same, so based on the previous page it should be a direct swap. It might be cheaper for you to just get a rav4 spindle though and use its brakes. 302mm but thinner discs.
CMS-GT4":3pmskg5n said:It might be cheaper for you to just get a rav4 spindle though and use its brakes. 302mm but thinner discs.
lumbercis":3r1lpgs5 said:Ahh, I see. Thread's just getting a bit confusing at this point.
dragstang86":20kidvr3 said:lumbercis":20kidvr3 said:Ahh, I see. Thread's just getting a bit confusing at this point.
I agree. There is many ideas mixed with fact it is hard to keep track of what is what. I nice organized summarized post would be nice.