Updating this a bit, I removed the old turbo and replaced it with my spare, fixed the O2 sensor wiring so there's a proper plug now and replaced the sensor, and installed the xiiimotorsports aluminum north-south crossmember bushings. Unfortunately it appears the front end of my car is tweaked slightly so getting the front bushings in was a pain, I ended up having to use the old bolts because I just couldn't get the new ones to grab those stupid loose nuts with the way things are. The rear ones went in like a dream though, thanks again to klue and xiii for supplying yet another part that fits perfectly.
I am a bit worried running the front end of the crossmember with the solid bushings, only because the stock squishy ones allowed the crossmember to not line up with the frame properly (it's out by probably 1/4"). The solid bushings were able to pull everything back in line but I'm worried the stresses of the bushings trying to hold everything straight while the motor mount is trying to push it apart might brake something during a hard shift or launch or something. Do you guys think this is cause for concern or no?