Abs ring

M

Mr Alltrac

Member

• Sep 28, 2015

• #1

Is it possible to remove the abs ring and put it on a axle that didn't have abs.

I bought an axle a few years ago without oNE and would like to get everything working again.

 

Z

zaluss

Member

• Sep 28, 2015

• #2

Mr Alltrac":2etyhspe said:

Is it possible to remove the abs ring and put it on a axle that didn't have abs.

I bought an axle a few years ago without oNE and would like to get everything working again.

Click to expand...

IIRC the ABS ring is on the hub, not the axle. The splines should be the same.

 

M

Mr Alltrac

Member

• Sep 28, 2015

• #3

viewtopic.php?t=50613

Very first pic. You can see the abs ring. It looks like a hub puller could grab it, not 100% sure tho.

 

Z

zaluss

Member

• Sep 28, 2015

• #4

Mr Alltrac":5vy8c8q1 said:

http://www.alltrac.net/phpBB2/viewtopic.php?t=50613

Very first pic. You can see the abs ring. It looks like a hub puller could grab it, not 100% sure tho.

Click to expand...

Is this for your Alltrac? There should be splines on either side for the front axles.

I'm not sure on the MR2 setup.

 

M

Mr Alltrac

Member

• Sep 28, 2015

• #5

Yes it's for an st185, my front axles are relatively setup like that. I'm not wanting the whole axle, just wondering if I could replace just the ring. Little gear looking thing at the end of the axle.

 

Y

yyonline

Member

• Sep 28, 2015

• #6

For ST185 you can do this, but it's tricky. I used a new ABS ring as I wasn't able to remove one without bending it.

http://www.amazon.com/Dorman-917-537-AB ... B009PJJK80

That kit also includes the dust shields that go on either side of the ABS ring.

 

M

Mr Alltrac

Member

• Sep 28, 2015

• #7

Awesome, just what I was looking for. Thank you.