*UPDATED*
Ok, so I am soldering in 205 plugs to the 185 harness where needed-
-O2 sensor
-Alternator
-Had to gind some material off the 205 ignitor to fit into the 185 plug, went on, but barely, may need to swap the plug over if it acts up
-Starter
-Knock sensor
-Oil pressure
I have the whole 185 harness in place, 95% plugged in....
Things I have left-
-Pin swap
-Wire up IC
Questions-
-Is the 185 injector resistor / fuel pump resistor ok to use?
-What plugs into that green vsv looking plug on the 205 charcoal canister?
-How do I hook up the temp probe in the downpipe?
Josh or scott... :shrug:
Thanks mang
Ok, so I am soldering in 205 plugs to the 185 harness where needed-
-O2 sensor
-Alternator
-Had to gind some material off the 205 ignitor to fit into the 185 plug, went on, but barely, may need to swap the plug over if it acts up
-Starter
-Knock sensor
-Oil pressure
I have the whole 185 harness in place, 95% plugged in....
Things I have left-
-Pin swap
-Wire up IC
Questions-
-Is the 185 injector resistor / fuel pump resistor ok to use?
-What plugs into that green vsv looking plug on the 205 charcoal canister?
-How do I hook up the temp probe in the downpipe?
Josh or scott... :shrug:
Thanks mang