Brand New Alltrac Wiring Harnesses

[suprakid95]

i would be in for a st165.

 

[darkturbo']

did you end up making these? i may be interested if the price is decent

 

[GT4times2]

Anything for the Caldina 3SGTE in a ST165? Demand is there.

 

[Dr Tweak]

We can build the ST215 portion but sourcing the connectors for the ST165 chassis is pretty difficult. We can, however, do the wiring conversion as long as you have an ST165 harness to supply us with.

-Doc

 

[alltracst185]

We can build the ST215 portion but sourcing the connectors for the ST165 chassis is pretty difficult. We can, however, do the wiring conversion as long as you have an ST165 harness to supply us with.

-Doc

How much would this cost to have done? Just a plain rebuild for the stock st165 motor and chasis

Thanks

 

[GT4times2]

We can build the ST215 portion but sourcing the connectors for the ST165 chassis is pretty difficult. We can, however, do the wiring conversion as long as you have an ST165 harness to supply us with.

-Doc

I have the ST165 harness/ECU. I'm looking into getting an ST215 motor, and dropping it into an ST165 in a few months. I was also wondering if you can just build a harness for an aftermarket EMS (stinger 4424 ems, which I have), to work with the ST215 motor and just call it a day. I have all the wiring, instructions and of course ECU.

Or could you have it mate to work with an AEM for an ST185 (which I also have)? :smokes:

I know it's a lot of questions/possibilities.

 

[Dr Tweak]

I could do either of those but STILL would need a good, complete ST165 harness to work with. That said, building a new ST215 harness from scratch would run somewhere around $750-$850.

Email me for more info: contact@tweakdperformance.com

-Doc

 

[darkturbo']

i have a spare jdm st185 harness with no connectors and a messy one thats in my alltrac at the moment, what'll it cost to either get the connectors put on or to get one built from scratch?(you can have the jdm one if i cant use it) im not sure if the jdm harness will work in an alltrac since the ecu is on the other side of the car but im told it will..
thanks!

 

[Dr Tweak]

If you send me the one from your alltrac I can build everything from the ECU to the engine brand new, I would just reuse the body connectors and everything else would be new, that would run about $850.

-Doc

 

[alltracst185]

I have the stock st165 harness...it just needs a rebuild because it is not charging the battery back (wiring problem) How much would that cost?

Thanks.

 

[Dr Tweak]

If it's just a refurbishing job, roughly $350 - $450.

-Doc