Thu Aug 18, 2016 5:12 am
Mon Aug 22, 2016 4:07 pm
Lamont wrote:awdmofo wrote:underscore wrote:In my head you'd need less clearance to slide it out the bottom than pull it out the top, but I could be wrong. Taking off the hood and front bumper should gain you some extra room.
Hood was taken off 2 months ago when I started working on it and kept hitting my head . I guess I could remove the front bumper but don't see how it will give me much more room unless you are talking about room for lifting the car and lowering the motor and trans out?
It sounds crazy, but once you remove the front bumper leave the crash bar in place. Then loop a strong chain around the front crash bar/bumper reinforcement. This will give you the leverage you'll need. Place wheel chocks on the rear tires, lift the car with an engine hoist and roll the motor out. You'll thank us later, and your also going to kick yourself for removing the head with the motor still in the car
Mon Aug 22, 2016 4:53 pm
underscore wrote:With the head gone he'll need a lot less clearance than usual to get it out, the front end might be able to go high enough just using normal jacks.
Tue Aug 23, 2016 10:48 pm
Wed Aug 24, 2016 4:12 pm
Wed Dec 28, 2016 6:19 am
© 2015 AllTrac.net
phpBB Mobile / SEO by Artodia.