Page 1 of 1

ST185 front Wheel Bearing Seal Kit

PostPosted: Thu Oct 22, 2020 7:40 pm
by 5thgenbliss
Anyone know the difference between these two front wheel bearing seal kits?

04422-20060 superceded by 20080
and
04422-20020 superceded by 20110

Last time I ordered, I got the 20110 set.

This time I'm about to order, and I'm quoted the 20060 superceded by 20080 version, but the 20110 version is still current too.

Re: ST185 front Wheel Bearing Seal Kit

PostPosted: Fri Oct 23, 2020 1:52 am
by grip-addict
No idea the difference between the two, but I did a wheel bearing job last month and successfully used 90369-38003-77 and 04422-20110.
Everything is working great with it.
Best of luck.

Re: ST185 front Wheel Bearing Seal Kit

PostPosted: Fri Oct 23, 2020 1:30 pm
by One-TracMind
Looks like one is RH side, the other LH side. Not sure why or how they'd be different, when I replaced my ST185 wheel bearings I got the same part # for both sides and didn't see any differences between right or left.

Re: ST185 front Wheel Bearing Seal Kit

PostPosted: Sun Oct 25, 2020 1:31 am
by 5thgenbliss
I did one side with 20110 and seems fine. I was just curious what the 20060 now 20080 is and if its the same.

Re: ST185 front Wheel Bearing Seal Kit

PostPosted: Sun Nov 15, 2020 5:10 am
by Corey
I purchased seal kit 04422- 20080 and it came with the ABS version of the dust ring (43246-12020) which has a taller lip and includes the cutout hole for the sensor to see through.

I also purchased just the non-abs version of the dust ring (43246-20010) out of curiosity. The lip is very short and has a longer cutout which I suspect is just for water to drain from if positioned to face downward.

After comparing the two, I decided to use the ABS version even though my car does not have ABS anymore (I installed non-abs knuckles but still have the ABS gear ring installed on the drive shafts) because the ABS dust ring would provide more protection against dust and debris in my opinion.

I believe the 04422- 20020 kit which is now superseded by 04422-20110 is the Non-ABS version of the seal kit with the smaller lipped dust ring.

This website described the difference with pictures:

https://minkara.carview.co.jp/userid/23 ... /note.aspx

Cheers

Re: ST185 front Wheel Bearing Seal Kit

PostPosted: Sun Nov 15, 2020 6:01 pm
by 5thgenbliss
Thanks Corey.
That totally explains it. ABS vs non ABS. I will also do what you did; use the ABS version (20080) even though my RC also doesn't have ABS.