UtahSleeper
Active member
So, I recently bought a st165 with a hacked up harness. What I am curious about, is soes anyone have any tips/ideas on repairing this?
My preferred plan is to find an unmolested one and just replace. Since those dont show up very often, I am looking to remove the hacked one and try and fix it. I imagine checking resistance on each wire is a good route and try and find the plastic pieces that went on the intake for securing, as well as the plastic that ran wires to the alternator.
Any other suggestions and/or tips? I am just trying to get this running in stock form and at a later time probably replace the harness or make a new one when I go standalone in a few years.
Thanks.
My preferred plan is to find an unmolested one and just replace. Since those dont show up very often, I am looking to remove the hacked one and try and fix it. I imagine checking resistance on each wire is a good route and try and find the plastic pieces that went on the intake for securing, as well as the plastic that ran wires to the alternator.
Any other suggestions and/or tips? I am just trying to get this running in stock form and at a later time probably replace the harness or make a new one when I go standalone in a few years.
Thanks.