Removal of Bumper Support

Visual Styling, Spoilers, and rims

Removal of Bumper Support

Postby -==L=a=N=c=E==- » Fri Oct 15, 2004 8:02 am

Well, my front bar is cracked and i need to get it fixed.

While i was at it, i was going to chop out the centre part, allowing for a huge opening for a FMIC. Apart from the fact the pumper will become kinda floopy, is there any side affect of doing it otherwise? like body rigidity etc...?

Bumper is a Genuine CS/RC/GroupA with all supports.

I want it to look something like this.

Members don't see the above ad. Register now - it's free!
User avatar
Club Member
Posts: 214
Joined: Sun Aug 08, 2004 7:22 pm
Location: Rosewood, Queensland, Australia

Postby illGT4 » Fri Oct 15, 2004 3:52 pm

That guy used to post around and about somewheres..

It's a CS/RC front modified quite a bit IIRC.

- Professional Motor Sports Driver & Instructor
- Vehicle Dynamics Specialist
- I4WDTA 4x4 Certified Trainer

User avatar
Established Member
Posts: 1820
Joined: Mon Aug 09, 2004 3:39 am
Location: New Castle PA

Postby spoolin_gt » Fri Oct 15, 2004 6:08 pm

why would you wanna take out the bumper support??most of the impact in accidents goes through the bumper support first....without can have a nasty dont wanna do's really dangerous...
Club Member
Posts: 99
Joined: Thu Oct 07, 2004 3:04 pm
Location: toronto

Return to Exterior Mods

Who is online

Users browsing this forum: No registered users and 2 guests