Tue Dec 09, 2014 4:07 pm
Wed Dec 10, 2014 8:03 am
Thu Apr 07, 2016 5:21 am
ZeroDrift wrote:Must say they work quite well- however with the low amp draw these have, the MR2 no longer has an operational hi-beam indicator lamp.
FC Zach wrote:Wonder how that can be corrected? ?
801Alltrac wrote:OMG that looks great, great work FC Zach
I knew they would look great, I wonder if there is a resistor would work
FC Zach wrote:I'm wondering if I could measure and record the ohms with the factory and new light installed then just buy a resistor sized close to the difference of the two? Does that make any sense? (It does in my head lol) Then do I just simply install it inline on the high beam wire?
801Alltrac wrote:That's what I think would work
MWP wrote:It wont.
You'll need to rewire the light in the dash.
Thu Apr 07, 2016 5:39 am
Thu Apr 07, 2016 9:05 am
What I did to fix this little issue: Instead of using a resistor I simply attached a small 194 bulb to each light.
Thu Apr 07, 2016 9:28 am
fussellbug wrote:What I did to fix this little issue: Instead of using a resistor I simply attached a small 194 bulb to each light.
Did you put the 194 bulb in series or parallel? Where did you physically put the bulb?
Thu Apr 07, 2016 3:30 pm
Thu Apr 07, 2016 9:04 pm
© 2015 AllTrac.net
phpBB Mobile / SEO by Artodia.