not12listen
New member
I have been doing some research on these, and have been in contact with a company that can build a custom (8mm) thick spacer. The device helps to lower the temperature of the intake manifold by limiting the transfer of heat from the head to the intake manifold. It can be used on any vehicle, regardless of whether it is NA, Supercharged or Turbo'd.
The company that makes these spacers does require a certain number of units to be produced, to give us consumers a reasonable price. I have already contacted the company asking what that magical number is.
As I am not a vendor, I cannot and will not put together a group buy.
If anyone is interested in such a device, I will gladly put you in contact with the company, thereby eliminating the middle man.
If someone else (with vendor status) wishes begin a group buy, I will forward all emails between myself and the company in question and assist where necessary.
The application in specific would fit the 3SGE and 3SGTE, but would NOT remove the TVIS portion of the intake. Of course, extended bolts/studs would be strongly suggest (or perhaps required) to make all of this work.
I am also seeing if they would create the same spacer for the 4AGE and 4AGZE... Same basic rules and requirements apply.
If anyone is interested, please let me know, so I can contact the company so as to demonstrate more than 1 person's interest in this product.
The company that makes these spacers does require a certain number of units to be produced, to give us consumers a reasonable price. I have already contacted the company asking what that magical number is.
As I am not a vendor, I cannot and will not put together a group buy.
If anyone is interested in such a device, I will gladly put you in contact with the company, thereby eliminating the middle man.
If someone else (with vendor status) wishes begin a group buy, I will forward all emails between myself and the company in question and assist where necessary.
The application in specific would fit the 3SGE and 3SGTE, but would NOT remove the TVIS portion of the intake. Of course, extended bolts/studs would be strongly suggest (or perhaps required) to make all of this work.
I am also seeing if they would create the same spacer for the 4AGE and 4AGZE... Same basic rules and requirements apply.
If anyone is interested, please let me know, so I can contact the company so as to demonstrate more than 1 person's interest in this product.