I'm in the middle of changing my clutch, so of course my engine is on the floor and of course I had one hell of a time with getting all the electrical clips unclipped throughout the whole project. Doesn't it seem like every one of them unclips differently? Some you have to pull a snap out, others you push in, but it's always kinda hard to tell.
I'm wondering that now when I go put everything back together, can I use some type grease on the outside of the clips to make it easier if i ever have to undo them again? I have some dialectic grease or something like that which I used on the tops of my spark plugs years ago, not sure if this would work or not? Any other ideas?
I'm wondering that now when I go put everything back together, can I use some type grease on the outside of the clips to make it easier if i ever have to undo them again? I have some dialectic grease or something like that which I used on the tops of my spark plugs years ago, not sure if this would work or not? Any other ideas?