Switch to full style
General Chat
Post a reply

Re: An All-Trac Legacy

Mon Jan 09, 2017 10:35 pm

Putting it that way doesn't make it sound any better
Members don't see the above ad. Register now

Re: An All-Trac Legacy

Mon Jan 09, 2017 10:47 pm

True, I'm just not sure if you're lucky or crazy. Or maybe both?

Re: An All-Trac Legacy

Tue Jan 10, 2017 2:10 am

Fair enough to say a little of both. But I certainly paid for it at the time.

Engine build time! You know it's been awhile based simply on the quality of the photos. I sent the block and head to the machine shop for the usual. The block was overbored to 86.5mm and the head had the seats reground, ported and polished. Based on Fraser's recommendations, I did not change valves or valve springs. My power goals did not require it. I also asked that the head not be reassembled so that I could check the work myself. It's a good thing I did because the cams were installed in the wrong positions. Enjoy some engine goodness!
Daytona 2014 007 (1).jpg
Daytona 2014 021 (1).jpg
Ground down the main bearing saddle supports, both to promote oil drainage and to strengthen crucial stress areas.
Daytona 2014 026 (1).jpg
Post a reply