SkagTits165
Member
zaluss":a7z2lnaq said:SkagTits165":a7z2lnaq said:A full day it took to fit. You cant really tell in the pictures, but i had to deform certain sections of the exhaust. I built a jig to hold the exhaust to bench, while i beat with rubber mallet. The largest deformity was maybe 2mm deep. When i first assembled pieces under car, i never thought that it would fit without cutting and welding, but it did. I had 2mm wood spacers to insert between the exhaust and the suspension/body where the clearances were tight. then as i tightened from front to back i would see where i needed to deform. It was quite the job
<Pics>
Oi. Maybe I'll be heading down to the exhaust shop afterall. I also inquired to Klue about a Bully clutch as it appears my ST205 swap needs one.
If you are going to a generic muffler shop, be prepared for some gross looking bends, not nice mandrel bends.
Probably look like this