Tue Feb 16, 2016 1:01 pm
Tue Feb 16, 2016 8:34 pm
Tue Feb 16, 2016 8:52 pm
Tue Feb 16, 2016 10:53 pm
Wed Feb 17, 2016 5:59 pm
1. The turbo is rated at around 95lb a minute so usually at or near it's max shaft speed most people will see between 825-925WHP. It can be pushed further but depends on how much shaft speed it has left in it. Consider the big HP gains at the lower boost pressure and reaching a point at 40PSI where the gains were diminishing quickly I would hazard that the turbo can't spin much faster without risking damage.
2. You can possibly extract more power by improving how the air is able to move through the motor but since I don't know enough about your car or platform I'm not sure where to point you.
3. Is the 1.19 divided? If so that housing will act like a .95 open housing at max flow but without back pressure who knows if it's holding you back.
Unfortunately without a shaft speed sensor, egt, and back pressure it's hard to know how much if left on the table if any.
Thu Feb 18, 2016 6:22 pm
Thu Feb 18, 2016 6:53 pm
Thu Feb 18, 2016 7:26 pm
Fri Feb 19, 2016 12:53 pm
Mon Feb 29, 2016 4:40 am
Mon Feb 29, 2016 4:54 pm
Mon Feb 29, 2016 6:01 pm
Mon Feb 29, 2016 11:26 pm
ChrisD wrote:-intake manifold design - could go back to the drawing board and tune runner lengths for top-end. Also could be worth considering plenum volume and ensuring an equally distributed flow.
-same with exhaust manifold. I know Full-Race only says it's 'close' to equal length. Could go custom with RacerX to get a true equal length built, long runner design...
-What size is your IC piping? Could play with that...
-Other obvious things...triple check for any boost leaks. Check the Aeromotive FPR, they seem to all leak out of the top nut. Mine did...don't want to leave any power on the table for things like that...
Toyotalevin wrote:Nice job . From 35psi it should definitely be in the 900 brackets you are consistent with the 90hp gain until the last 5psi which is 33hp that's a lot to drop. I think it could be a flow problem thou
Toyotalevin wrote:Can give me a link to Mario would love to get the center viscous upgrade
Tue Mar 01, 2016 4:00 am
Tue Mar 01, 2016 10:57 am
© 2018 AllTrac.net
phpBB Mobile / SEO by Artodia.