Hi,
The engine mounts on my ST165 have definatley passed their used-by date. Now certified crap.
I have been looking around and ready quite a bit on mounts, and especially poly bush type. I can get my engine mounts re-bushed in poly-rubber locally ( as long as I supply the stripped out metal housing) for about $140 to $150 each. I can get after-market rubber ones that range from $140 for the front & rear to $280.00 each for the other 2. Bloody expensive. Especially when I see what you guys pay for them
I've noted the threads on here about engine mounts, especially poly bush type engine mounts and the recommendation for Speedsource engine mounts.
Ok I have have been to their site and looked at bush kits for the ST165. It shows the kit and lists 4 poly bushes and 2 steel sleeves. To me that is only enough for 2 engine mounts, the front and rear.
Please, you guys that have some experience with these mounts, can you tell me, is there another kit for the top tranny end and the cambelt cover end mounts? Or are they all the same poly-bushes and I order 2 kits? Or do I have to source elsewhere engine mounts for the other 2 locations? (12372A) and (12362)
I have emailed Speedsource asking this question, but...... I am not over confident I will get a reply if you get my drift.
Attached is a copy of DIYtoyo showing the mounts for my car.
Thanks for any help you can give.
Fred.
The engine mounts on my ST165 have definatley passed their used-by date. Now certified crap.
I have been looking around and ready quite a bit on mounts, and especially poly bush type. I can get my engine mounts re-bushed in poly-rubber locally ( as long as I supply the stripped out metal housing) for about $140 to $150 each. I can get after-market rubber ones that range from $140 for the front & rear to $280.00 each for the other 2. Bloody expensive. Especially when I see what you guys pay for them
I've noted the threads on here about engine mounts, especially poly bush type engine mounts and the recommendation for Speedsource engine mounts.
Ok I have have been to their site and looked at bush kits for the ST165. It shows the kit and lists 4 poly bushes and 2 steel sleeves. To me that is only enough for 2 engine mounts, the front and rear.
Please, you guys that have some experience with these mounts, can you tell me, is there another kit for the top tranny end and the cambelt cover end mounts? Or are they all the same poly-bushes and I order 2 kits? Or do I have to source elsewhere engine mounts for the other 2 locations? (12372A) and (12362)
I have emailed Speedsource asking this question, but...... I am not over confident I will get a reply if you get my drift.
Attached is a copy of DIYtoyo showing the mounts for my car.
Thanks for any help you can give.
Fred.