Switch to full style
JDM GT Four, ST185RC and ST205.
Post a reply

What's this wire going through the heat shield?

Fri Sep 11, 2020 8:36 pm

So I'm trying to figure out what this wire is that's going through the heat shield on my to-be-delivered WRC. Clearly drilling through the heat shield was not the cleanest solution here, but are there any ideas as to what it'd be going to?

I'm thinking it's to measure the exhaust temperatures at the manifold? Activating anti-lag? (Hope not!) :shrug:

Image

Image
Members don't see the above ad. Register now

Re: What's this wire going through the heat shield?

Fri Sep 11, 2020 8:42 pm

It's probably an EGT probe. The antilag piping is just a dummy so some people drill out one of the bungs to use it for EGT.

Re: What's this wire going through the heat shield?

Fri Sep 11, 2020 8:50 pm

underscore wrote:It's probably an EGT probe. The antilag piping is just a dummy so some people drill out one of the bungs to use it for EGT.


Thanks buddy! I knew antilag was under there, but I didn't know about drilling the bungs for EGT. Makes sense since the car also has an electronic boost controller and vacuum gauge to keep an eye on things.

Re: What's this wire going through the heat shield?

Sun Sep 13, 2020 4:10 am

man, I don't get why people put single probes that high up in the exhaust flow. if you're gonna drop a single, do it low and make it look clean. Or do 4 probes up top so you can manipulate fuel per-cylinder.
HeyKennyii: i'm expecting you to do some air injection with those ports ;)
Post a reply