hey all, don't own an alltrac but i'm gathering the parts for 'the swap'. because i'm going to be running the cs hood i'm going fmic right away. i don't personally like the way the intake pipe on most swaps come straight down from the tb and over the exhaust manifold (performance reasons) and i don't want to wrap any pipes over to the passenger side of the engine bay because again i'm getting them close to the exhaust manifold and adding pipe length. so i'm going with a side-entry intake manifold. this leads to what i don't know much about: 1. because the manifold houses a 70mm throttle body do i need to upgrade the mass airflow sensor? also, will the stock ecu be able to compensate no problem for the increase in airflow and be able to feed more fuel accordingly? 2. is clocking the turbo with this setup going to be necessary or is that only on a need-be basis for fitting of the pipes? thanks in advance-