Pulling problem

M

MR. LEADFOOT

New member
My ST165 is pulling to right. The only thing I've done before it started
to pull was installed Whiteline front sway bar. If the sway bar wasnt centered right would it be the problem.
What I done to tryed to fix the problem is new Super Pro bushings, 4 weel alinement and checked tire psi.
Any ideas what could be the problem.

THANKS
 
R

RIalltrac

Active member
did they give you a printout on the alignment? If they didnt I would go back and make them give you one. then you can see how badly they set it up. I would definately point my finger at an alignment problem.
 
M

MR. LEADFOOT

New member
It doesnt pull when braking. ( I'll check just in case )
And I got new axels, cv joints , boots , ect. put on last year.
How about the hub bearings, if they where bad whould it pull.
I'll just go back and halla at them to re-aline it.
Thanks for your input folks
 
G

Greg Forbes

New member
I have a really bad pulling problem also, but mine's a ST185.

Looking at the alignment data, it's because I have way too little caster on the side it pulls towards. (.40 caster on the left and it dives left.)

Fixes that have been discussed have been moving the location of the ball joint (which I still don't understand) or bending the lower control arm (which nobody really wants to do.) However, nothing beyond alignments has been tried, and it still pulls badly.
 
You must log in or register to reply here.
Top