CMS-GT4
Active member
That may be my problem. I am using my INT as a power source (B) before the diode. I thought it provided the 12v source.
Could it be that it makes enough power from the INT to prevent code 54 at low rpms or idle but when there is a larger draw that it can not ive enough power to the source?
Where should INT be hooked up in this equation?
Could it be that it makes enough power from the INT to prevent code 54 at low rpms or idle but when there is a larger draw that it can not ive enough power to the source?
Where should INT be hooked up in this equation?