Looking to get rid of the O2 heater code with a resistor, but I'm not sure where to insert it into the O2 sensor 4-pin port.
Also it's not an issue of the O2 sensor being bad, I've swapped it out for a Wideband and want to get rid of the CEL.
SOLVED:
Sorry, newbie to everything wiring. Fixed it by running 2 5.6K ohm resistors from the 2 orange/black wires to the red/green wire, it's not like a normal circuit where any ground works it seems the orange/black wires are "connected" only those once connected can complete the circuit. Sorry, can't word it better.
Also it's not an issue of the O2 sensor being bad, I've swapped it out for a Wideband and want to get rid of the CEL.
SOLVED:
Sorry, newbie to everything wiring. Fixed it by running 2 5.6K ohm resistors from the 2 orange/black wires to the red/green wire, it's not like a normal circuit where any ground works it seems the orange/black wires are "connected" only those once connected can complete the circuit. Sorry, can't word it better.