I'm going to install my home-made manual boost controller this weekend, and I know to cap off the line to the Turbo VSV. I'm running a stock CT26 without a BOV. I couldn't find the detail I'm looking for on the board here.
Tell me if I have this right: I leave the hose connecting the CT26 compressor to the wastegate actuator, and connect the MBC to the other port where the Turbo VSV was connected to. Where do I connect the "exit" port from the mbc to? Does this just vent to atmosphere? That doesn't seem right. It looks to me like the Turbo VSV routes its air back to the intake pipe upstream from the compressor.
If I need longer hoses, what can I use? I have some small Toyota hoses, but they are smaller diameter than the wastegate actuator hoses.
Tell me if I have this right: I leave the hose connecting the CT26 compressor to the wastegate actuator, and connect the MBC to the other port where the Turbo VSV was connected to. Where do I connect the "exit" port from the mbc to? Does this just vent to atmosphere? That doesn't seem right. It looks to me like the Turbo VSV routes its air back to the intake pipe upstream from the compressor.
If I need longer hoses, what can I use? I have some small Toyota hoses, but they are smaller diameter than the wastegate actuator hoses.