___Scott___
Active member
My EPC went down with a hard drive crash about a year ago, and I haven't been able to get it working since. So, I need to ask someone with a working EPC for a few part numbers. All are for a 1st-gen 3S-GTE just in case it matters (like for the oil pump gasket.)
- Valve stem seals (both intake and exhaust)
- Intake gaskets (one on each side of the TVIS plate)
- exhaust gaskets (I thought I had a set but I can't find them)
- Oil pump "o-ring style" gasket (as seen below)
- Starter ring-gear, not the whole flywheel (as seen below)
- Dowel/tube thing that aligns the head to the block and holds the gasket in place while you torque the head down (as seen below)
Oil pump o-ring style gasket
Starter ring-gear
Dowel/tube
- Valve stem seals (both intake and exhaust)
- Intake gaskets (one on each side of the TVIS plate)
- exhaust gaskets (I thought I had a set but I can't find them)
- Oil pump "o-ring style" gasket (as seen below)
- Starter ring-gear, not the whole flywheel (as seen below)
- Dowel/tube thing that aligns the head to the block and holds the gasket in place while you torque the head down (as seen below)
Oil pump o-ring style gasket
Starter ring-gear
Dowel/tube