boost

sleeper

New member
I have a st165 with a autronic smc....
and the problem is: when i`m boosting the autronic shows 215kpa (1.15kg) but the autometer boost gauge shows 19psi (1.4kg?)

whitch of them is correkt???
how can i test it??
 

Gary

Moderator
Where is the boost/vac source for the Autometer gauge?
The Autometer is not such an accurate gauge IMO.
 

Terboman

New member
Gary":1wnl9v5s said:
.....
The Autometer is not such an accurate gauge IMO.


So, you think my JDM white faced Autometer Phantom gauges are no good eh Gary? AHA! Finally the truth comes out!! LMAO!! :D

Nah, I'd have to agree. Autometer is not bad by any means but I wouldn't buy another one. If I had to redo my gauges...I'd run all Omorimeter.

As far as the Autronic vs the Autometer boost reading.....my money is on the Autronic internal sensor assuming same source and no problems w/ your lines.
 
Top