gtfour93":1wjtyqx9 said:BLOWNTACO":1wjtyqx9 said:RC emblem
75444-2B240
Rain Visors:
08613-20130
75444-2B180 PLATE, BACK DOOR (turbo 4WD)
BTW, what is the part number for the rear window visor?
This is something quite similar to a MKIII Supra (JZA70).
Where are the pictures?Corey Darling":1em8gx4p said:Bump? thanks
This one is not too easyCorey Darling":2a9p7ren said:Here are the two hoses.
Conan":bprfk5c0 said:You sure you wanna know all of this? :twisted:Toxygene":bprfk5c0 said:Anyone have the part#'s for the ST185 Water to Air intercooler, the pump for the WTA intercooler, and the stock WTA radiator, and any wiring and hoses associated with that system?
Yes, there's the transmission cooler, AC tank, main fan and head lamp sprayer hoses.TheNubkins":2juhbbbv said:Are there any parts on this diagram that do not comprise the air/water intercooler setup
I'm not sure, you would need a new IC to TB hose and maybe drill a few holes here and there Also, you need to wire the pump somewhere.TheNubkins":2juhbbbv said:and would I be correct to assume that if I were to purchase all the parts on this diagram I would be able to install them in my stock North American All Trac Turbo to replace my air/air intercooler setup?
It should be somewhere around here, search and you will find :wink:TheNubkins":2juhbbbv said:Anyone know the part number for the turbo-to-manifold gasket?
Conan":2l4cp3r5 said:Around a grand. US part is half the price I doubt it fits though.Flying Bajan":2l4cp3r5 said:So I've heard... Any idea on price ?
83242-15610 for the narrow body shared with some ST182s.Flying Bajan":2l4cp3r5 said:Also, my car is a 1990 narrow body JDM car, not questioning you, but are you sure that is the right number ?
I have checked again, it's the same number.Flying Bajan":28keysrx said:Conan, been searching and all the sources I've tried are saying this number is wrong... Any possibility of them being right ?
I guess I could but it would cost a LOT from the dealer.Flying Bajan":28keysrx said:Can you source one ?
Nitro_Alltrac":12nlbfmk said:I found these numbers on the very first page but I'm not sure which one is the one I need. I am needing the number for the two washer/gaskets that go on the turbo oil feed line where it attaches to the block. There is one on the top and one of the bottom of the banjo fitting. The numbers I found are:
gasket, joint for turbo oil pipe - 15526-88381
Turbo oil line gasket - 15471-88580
Which one is correct for what I need?
Thanks.